Pull-Mor Tires to be used with worn or Non Pull-Mor Steam Wheels to assist in traction. Can also be used with any non grooved Steam Wheel
Pack of 4
Dimensions: ID 25mm, Thickness 0.55mm, and Width 3mm
Installation:
1. Remove linkage on one side of the locomotive
2. Scrape off any old rubber
3. Add four drops of glue to the wheel at four points. NOTE: if the wheel had old rubber, you may not need glue.
4. Slide tire over the wheel by holding one side and using a toothpick, small screwdriver, or dental pick to stretch it around.
5. Replace linkage and repeat for other side.